 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : 3D-printed case for the Picomite HDMI and Peter's adapter board
| Author | Message | ||||
twofingers Guru  Joined: 02/06/2014 Location: GermanyPosts: 1769 |
A 3D-printed case for the Picomite HDMI and Peter's adapter board (supplied by Plasma). The required components are the printed two (or three) case parts, two M3/3mm threaded screws, and two M3 hot melt insert nuts, h=6.0mm, OD=4.6mm, core=3.9mm (or M3x3x4.5). If you don't like hot melt insert nuts, there is also a version for sheet metal screws.    PicoHDMI Case.zip Feedback appreciated. Best regards Michael Edited 2024-09-22 00:43 by twofingers ‚My name is Ozymandias, king of kings Look on my works, ye Mighty, and despair!‘ Nothing beside remains. Round the decay Of that colossal wreck, boundless and bare The lone and ... |
||||
Plasmamac Guru Joined: 31/01/2019 Location: GermanyPosts: 620 |
thx Michael , fusion 360? Plasma |
||||
| twofingers Guru Joined: 02/06/2014 Location: GermanyPosts: 1769 |
Yes, it is always good to keep practicing. Kind regards Michael ‚My name is Ozymandias, king of kings Look on my works, ye Mighty, and despair!‘ Nothing beside remains. Round the decay Of that colossal wreck, boundless and bare The lone and ... |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2026 |
